Buy Autonomous light sensor Sunis Wirefree RTS 9013075 at Factory Prices

Functionality of the SUNIS RTS 9013075 Solar sensor

The SUNIS RTS 9013075 solar sensor provides automatic control of internal blinds, vertical external blinds, terrace (awnings) and roller shutters. Thanks to the light level programming function, it remembers your preferences and automatically applies them, providing optimal thermal comfort, even in your absence!

Detection of the appearance of the sun:

When the brightness of the ambient lighting exceeds the set threshold on the SUNIS RTS solar sensor, a command to lower the blinds or shutters comes within 2 minutes. If a preferred position has been set, it is accepted. Otherwise, the blinds or shutters are completely closed.

Detection of the disappearance of the sun:

When the ambient light brightness drops below the set threshold, a countdown starts from 10 to 30 minutes (depending on sunlight), after which a command is sent to raise the blinds or shutters.

The light level can be changed at any time according to your preferences.

Compatibility of Solar light sensor 9013075

The 9013075 solar light sensor is only compatible with Somfy® RTS blinds and shutters motors, including the following models: ALTUS RTS, LT RTS CSI, OXIMO RTS, OREA RTS, SUNEA CSI RTS, Universal receiver RTS and CENTRALIS UNO RTS.

To use the sensor, you will also need a compatible RTS transmitter, such as Telis Soliris RTS, Telis 4 Soliris RTS, Telis Composio RTS or Telis Impresario chronis RTS. The command sent by the sensor is transmitted to the remote control, which then transmits the information to the motor.

Installing a Solar light sensor

The solar light sensor for RTS motors must be installed outside, on a vertical surface exposed to natural light. Make sure that the sensor is not located too close to artificial lighting or always in the shade. It should also be installed in a convenient place for cleaning. The choice of location affects the daily efficiency of the sensor. Installation takes only a few moments and requires the use of two screws ø4.5 mm (not included in the package).

Technical characteristics of the Solar light sensor 9013075

• Radio Frequency: 433.42 MHz


• Range: 200 meters between two concrete walls and 200 meters in open space


• Dimensions: Ø 100 mm, P 50 mm


• Comes with a mounting bracket


• Distance between mounting holes: 40 mm


• Protection level (IP): 44


• Operating temperatures: -20°C to 60°C


• Battery life: 24 hours without additional lighting


• Allows you to control one or a group of specific motors using a remote control


• Installation: Do not install on metal and keep a distance of 30 cm between the two sensors